Master Shaft w Phoenix

🕗 godziny otwarcia

komentarze 5

• en

  Beau Borgersen

  :: 30 October 2017 20:50:19

  Trevor is a true professional. He spent time discussing my plans over the phone prior to ever getting my business, which meant a lot. I had him rebuild my two piece Silverado driveshaft with new U joints and center support. If you have this setup, please heed his advice and have it balanced. These two piece shafts are known to have balance issues. Trevor had been here a LONG time and knows his trade. Highly recommend and very happy. Thanks again!

• 

  Jose Che

  :: 21 September 2017 18:58:00

  Amazing attention to detail! And honest! It’s pretty hard to find someone who is knowledgeable. All he does is driveshafts. He was able to fix the Ujoints, a yoke that was out of place and a carrier bearing that was installed backwards from a previous repair. He marked everything up in case I worked on it later on. My truck is a 2011 Tacoma 4x4. Dropped it off Wed and it was ready Thurs. he also found that my shaft didn’t need balancing, just a bad yoke. So he said if I skipped the balancing it would save me some money. Now everything works 100% and no more vibrations! Come here and save yourself time and some money. He found a customer for life

• 

  Mayhem ___

  :: 21 June 2016 08:37:11

  Great place to get your drivelines done

• en

  Stu Pidasso

  :: 12 February 2015 23:37:58

  Hello from Payson AZ Trevor at master shaft has fabricated a number of driveshafts for me. I deal exclusively in Studebaker products. It goes without saying that there are no sources for NOS driveline parts. He fabricates for my vehicles and I've never had a comeback for any reason. In addition I have sent a number of customers directly to him and he has always delivered in a professional and courteous manner. Even once on a two piece shaft which he repaired and turned out in less than one day. Thanks Trevor. Ken Michael, Studebakers Only, Payson AZ

• en

  Steve Huff

  :: 02 January 2013 13:27:16

  It is on grant, not grand.....